Linijsko pojačalo TERRA HA-20R65. Pojačanje 36 dB. SiGe Chipset.
Linijsko pojačalo TERRA 20R65. Pojačanje 36 dB..Izlazni nivo : 109 dBµV. SiGe Silikon Germaniski chipset za vrhunske rezultate.Die Cast kučište.
181,83 €
2
Opis
House/building amplifier HA-205R65 is equipped with output stage using Gal-As semiconductor components, working in push-pull mode. The amplifier has been designed for cable and MATV systems with return path/channel and enables signal level equalization in forward and return path.
Another advantage of the HA-205R65 amplifier is the driver stage based on SiGe (silicon-germanium) chip. This solution significantly reduces nonlinear distortion, especially that of the second order.
The amplifier has built-in attenuator, test connectors (-20 dB), active return path, and allows for compensation of the cable attenuation dependent on frequency. All connectors are of the F-type.
The compensation circuits have two stages in order to guarantee maximum signal-to-noise ratio.
The die-cast housing provides high screening efficiency by preventing the penetration of interfering signals to the unit. High level of output signal and built-in compensation of the cable attenuation characteristics allow for building large RF distribution systems.
Key features
- push-pull output stage made of Gal-As semiconductor components
- attenuator and cable attenuation equalizer (forward path)
- equalizer between the 1st and 2nd stage of forward path
- selectable active/passive return path
- attenuator at the input of return path
- attenuator and equalizer at the output of return path
- test connector (input, -20 dB)
- test connector (output, -20 dB)
Specifications
| Name | HA-205R65 | ||
| Code | R82307 | ||
| Forward path | |||
| Frequency range [MHz] | 47 – 862 | ||
| Gain [dB] | 27/36 | ||
| Pass-band ripple [dB] | ± 0.75 | ||
| Gain adjustment [dB] | 18 | ||
| Cable loss compensation [dB] | 18 | ||
| Input and output return loss | ≥ 14 dB at 40 MHz, -1.5 dB/octave, not less than 10 dB | ||
| Output level CTB, CSO (EN50083-3) [dBμV] | 109 | ||
| Noise figure [dB] | 7.5 | ||
| Test point loss [dB] | -20 | ||
| Return path | |||
| Frequency range [MHz] | 5 – 65 | ||
| Gain [dB] | 27/-4 | ||
| Pass-band ripple [dB] | ± 0.75 | ||
| Gain adjustment [dB] | 18 | ||
| Cable loss compensation [dB] | -6/-3/0 | ||
| Input attenuator [dB] | -10/0 | ||
| Return loss (output) [dB] | > 14 | ||
| Max output level IMD3=60 dB (DIN45004B) [dBμV] | 115 | ||
| Noise figure [dB] | 7 | ||
| General | |||
| Supply voltage; power consumption | 230 VAC, 50 Hz; 5 W | ||
| Temperature operating range [ºC] | -20…+50 | ||
| Dimensions (packaging) [mm] | 185x91x47 | ||
| Weight [kg] | 0.7 | ||
